Centreless plunge grinding

Centreless plunge grinding

Centreless plunge grinding

This grinding process is used whenever the workpiece is unsuitable for through-feed grinding due to its geometry. (e.g. caused by an array of different outer diameters).

In terms of its basic structure it corresponds to the centreless through-feed grinding process in many aspects. In plunge grinding, however, material removal is realised by a tangential feed of the grinding wheel.

Due to the triangular arrangement of the workpiece between the grinding wheel, guide and control wheel, it enables a much higher concentricity and dimensional accuracy to be achieved.

Vitrified bonded aluminium oxide grinding wheels are predominantly used in this process.

ATLANTIC GmbH
Gartenstr. 7 - 17
53229 Bonn, Germany

Tel.: +49 (0) 228 408-0
Fax: +49 (0) 228 408-290
infoqRWhaiQeqBuxY5qXhWmwnatlantic-bonnde